So today is the day where all fyp's students been waiting for. We are going to do the fyp presentation in front of two assessors, Madam Johara and Madam Amalina, from the Electronic section. The presentation went smoothly. So here we would like to give our many thanks for those who helped us on this project and also to our supervisor who had been with us for one year to supervise us. Alhamdulillah we managed to do the presentation well.
The Deepest Bin
Friday, 20 December 2013
Friday, 13 December 2013
WEEK 13 (Our Project)
Here is the video of our project.
Since
this project is important to monitor the waste management system, there is some
recommendations to improve this project are here by proposed. Some of the
suggestions for future development are listed as below :
1.
Use
RFID as tracking device.
RFID
is the wireless non-contact use of radio-frequency electromagnetic fields to
transfer data, for the purposes of automatically identifying and tracking tags
attached to the dustbin. This will prevent the dustbin from getting stolen and
able to track the dustbin if it is being move to somewhere else.
2.
Place
a LED advertisement board
It
can help the waste management service provider to generate income by offering
an advertisement such as nearest hotel promotion that can be display and seen
by the visitor and tourist.
3.
Use
WIFI instead of GSM
By
using WIFI, it can helps to reduce cost for credit top up and maintenance. By
using WIFI, it can provide smartphone applications that can be access by
public. By downloading the application, maybe the public can give feedback,
rating and recommendation that will benefit the waste management service
provider to increase their effectiveness.
Saturday, 7 December 2013
WEEK 12 (Report Preparation)
This week, we worked on the final report. We did chapter 1 and 2. We also summarized what we did on both chapters. Chapter 1 is where we cover the introduction, while chapter 2 we cover the literature review. However, we had a little problem with chapter 2. It was because there was no previous project of smart dustbin at our university. So what we did was we reviewed the smart dustbin on the internet, and also we made the literature review on GSM modem.
Friday, 29 November 2013
WEEK 11 (Poster & Pamplet)
The fyp exhibition is around the corner. It is nerve-wrecking for all students who are taking fyp this semester. So today, at 3pm, we had FYP briefing at TTL. This was the second briefing. The lecturer gave informations regarding FYP presentation and exhibition that will be held on the Engineering Day.
This week, we worked on the poster and pamplet. This were the requirements of fyp presentation.
These are the outlines for our poster and pamplet.
This week, we worked on the poster and pamplet. This were the requirements of fyp presentation.
These are the outlines for our poster and pamplet.
Poster
Outer Cover Pamplet
Inner Cover Pamplet
Friday, 22 November 2013
WEEK 10 (Finishing Product)
Most of all, we had finished the circuit but did not on the product. As for the dustbin, we borrowed the admin's small dustbin and as for the casing, we used cardboard to place the circuit on it.
This week we finalized the finishing product.
This week we finalized the finishing product.
Saturday, 16 November 2013
WEEK 9 (Project Result)
The
result of the tests performed between the connection of hardware, software and
operational range of the GSM module. The control panel circuit was connected
with the power supply, then the infrared sensor detect movement and produce a
long fall sound. When the dustbin is full the infrared sensor will detect and
send command to GSM modem through microcontroller. Then its result to receiving
alert that indicate the dustbin is full as shown in poster.
Saturday, 9 November 2013
WEEK 8 (Control Panel)
This we start work on our final report and also draw the circuit diagram for control panel circuit to be attach in final report at hardware development section.
Subscribe to:
Posts (Atom)